A&D TM-2655 Blood Pressure Monitor A&D TM-2655 Blood Pressure Monitor thermal printer (This chapter is applicable only to the TM-2655P.) With the power turned on, install the printer paper as follows: 1. Cut the top end of the printer paper with scissors. If the end is not smooth, it may cause a paper jam or damage the printer head. 2. Press lightly on the center of the printer cover to open the cover. 3. Raise the lever located on the right side of the printer. Set the lever to the up position (2) of the figure . The insertion of the printer paper is enabled. 4. Insert the printer paper into the paper feed slot as shown. The paper is fed automatically. 5. Press the PAPER FEED switch to feed the paper by about 10 cm. Confirm that the paper is fed straight. If not, re-install the paper because it may cause a paper jam. Printer cover Raise the lever to the up position (2) . Lever PAPER FEED switch